Scalloped Copper Bangle Bracelet
This Scalloped Copper Bangle Bracelet started out as a flat strip of 16 gauge copper sheet metal, 8 1/4 inches long by 1 3/4 inches wide. I then formed the strip into a circular bangle and soldered the joint with hard Silver solder. Next, the bangle was synclastically raised on a steel sinusoidal stake with a delrin mallet. The fluting was produced by chasing the copper over a series of fluting stakes and annealings (8 in total), then plannished to remove any hammering marks. After polishing, the Silver seem was copper plated.
VN:F [1.9.22_1171]Scalloped Copper Bangle Bracelet, 8.6 out of 10 based on 35 ratings
- Handmade Designer Jewelry
- Carnelian Necklace and Sunstone Bronze Ring Featured on Polyvore
- All about Amber: Choosing Amber Jewelry